Fully automatic candle filter is an automatic pressure filter. It is mainly composed of a cylinder, filter element, filter cloth, filter aid, computer control system and accessories. As a large-scale equipment on the production line, the filter is also commonly called a candle filter. In order to enable customers to solve related faults in time when problems occur during use, today Lifelt has sorted out some solutions to related faults for everyone.
Reasons and solutions for candle filter failure:
I. Flow rate of candle filter drops suddenly:
1. End cap is not tight; tighten the end cap
2. Pipe valve is not open; open the valve
3. Low intake pressure; check the cause and increase intake pressure
4. O-ring leaks; replace
5. Pipe leaks; repair the pipe
II. Increased pressure drop of candle filter:
1. Filter element is blocked or adsorbed in large amount; replace the filter element
2. Filter element is aged; replace the filter element
3. Large intake impurity load; perform pretreatment
4. Water accumulates in the filter cartridge; find out the cause and remove the water accumulation
5. Automatic drainer fails; adjust, repair or replace the drainer
6. The filter is not installed horizontally; reinstall
III. Poor filtering effect of candle filter:
1. No pretreatment of intake air; add a pre-filter
2. Filter element is aged; replace the filter element
3. The air contains chemicals that the filter element cannot adsorb; pre-treat according to the situation
4. Flow rate Exceeding the rated value; replacing the large flow filter
5. There is an air flow short circuit inside the filter; find the cause and treat it symptomatically
6. The filter element fixing screws are not tightened; tighten the filter element
7. The filter inlet and outlet are connected in reverse; identify the marked direction and reconnect
8. The downstream pipeline is not clean; flush the downstream pipeline
9. There are residual pollutants at the point of use; remove the residual pollutants
10. The bypass valve is not closed; tighten the bypass valve
IV. the candle filter does not work:
1. The inlet and outlet valves are not opened; open the valve
2. The filter element is seriously blocked; replace the filter element
3. The filter is damaged; replace the filter
4. The piping is blocked; repair the piping
The above are the related product failure problems and solutions of the candle filter. If you encounter this situation during your use, you can solve it in time according to the relevant solutions later. If you have other problems, please feel free to contact us to ensure the normal operation and production guarantee of the product.